Racking a PPG Wave 2.2 – part 1 – intro

Intro

I recently got this “racked” PPG Wave 2.2. The history of it is quite unknown, but this brutal treatment was done in Germany by someone else than me. I’m innocent!

Someone has cut this Wave in half, removed the keyboard and put the right side  on top of the left side using standard screws and standoffs from a hardware store. It’s a shame since it looks as though the panel was in great condition – most Waves suffer from the graphics peeling of, especially in the area near the logo close to the push buttons.

Software wise it’s running OS V6 and has MIDI. MIDI is the way to control it since it has no keyboard. Since it’s a PPG Wave 2.2, it’s compatible with the Waveterm A – which I don’t have. There’s however an upgraded OS, V8.3, which makes the PPG Wave 2.2 compatible with Waveterm C, a software version of the Waveterm A and B.

Unfortunately, the serial is unknown as on most PPG Waves. It was hand written on a label on the back with a permanent pen that wasn’t as permanent as it was supposed to. It is probably an early/mid PPG Wave 2.2 as it has the same display as the Wave 2 but is equipped with factory midi.

I asked myself – what have I done – buying an expensive piece of junk like this that could electrocute me. And the racking procedure won’t be cheap and will take a lot of man hours. However, I’m running out of space in the studio and PPG Wave 2.2s don’t grow on trees, especially if they’re not upgraded with 2.3 voice cards. So I decided to take on this challenge and make myself a one of a kind rare PPG Wave 2.2 rack. I guess my metal skills from working with cars will be needed…

The width problem

The problem with the current “racking” is that it won’t fit in a standard 19″ rack – it’s simply too wide! A standard 19″ rack case has a panel width of 19″ (483 mm) , but the case width is often closer to about  17.5″. I’ve found a rack case supplier that has a model with an external width of 435 mm and inside width of 432 mm. This means that 432 mm is what I have to deal with.

The mainboard with all voice cards that is on the lower section is luckily enough around 430 mm. There’s also possibility to shave off a couple of mms at the far ends. The pots are placed on a board that is around 400 mm. The “Basis” and “Master Volume” pots to the far left are not on the board and can be placed anywhere.

The upper section has the power supply and MIDI and audio outputs at the back. They can easily fit within in the width. The biggest problem is the so called digital board that has the keypads and the LCD display. Together they have a total width of 460 mm so they can impossibly fit. One solution is to cut boards so one end is in a 90 degree angle (like this racked 2.3). I have  chosen a different path – changing the display to a more modern and narrower one that also has backlight.

The original display must have cost a fortune back then, and it’s not directly compatible with modern displays. Therefore the digital board and display will be sent to Virtual Music in Austria to be modified.

I won’t reuse the original panel metal since a few things will have to be modified and moved around. Instead I will create new original looking graphics for the faceplate so it looks factory.

The plan summarized

  1. Make a plan
  2. Change the display to a narrower modern one with backlight
  3. Upgrade the OS to V8.3
  4. Put everything in a rack case
  5. Create new graphics